In the run box, type: For.(If you just want a bootable recovery console I downloaded one some time ago as an iso with just the files required to run it, it is less than 10mb total. Unfortunately I have no idea now where i got it then.)4. From wxp10.zip copy w2ksect.bin win51 and win51ip to the root of ubcd5. Go into i386 and delete bootfix.bin (unless you want to hit any key to boot from cd)6. If for some reason you want more than one xp version on a disc rename i386 and then take a hex editor and replace any occurance of i386 in /w2ksect.bin and /i386/SETUPLDR.BIN with whatever you are naming your folder (probably a good idea to keep it short) this works fine with the recovery console only but i have no idea what additional settings would be required for a full xp install7. Copy all the files from i386 off your xp setup cd into the root of the ubcd (ie /ubcd/i386)Download Windows XP Recovery Console Credit for this download goes to Dean Adams.Oh, okay, that probably sounded like gibberish, but it's true. Sometimes the file system of your boot volume gets corrupted. But what happens when you can't even get to the recovery console?Yes, it does happen.
![]() ![]() Xp Recovery Console Iso With JustAs if it weren't enough, INSERT is a very small download (in relation to other Linux distributions). Additionally, you have full read and write capabilities for Windows XP's NTFS file system (which isn't included in most Linux distributions. It comes with a lot of utilities designed to perform forensics and fixing systems (yes, even Windows XP!). First step: download INSERTINSERT is the Inside Security Linux distribution. Now, pay attention, because this solution does require some elbow grease, but if you need your files right away, you'd better be prepared. Take it with a grain of salt.After INSERT boots, you'll see a prompt with a nice logo.Type insert 2 and hit ENTER. Step two: boot into INSERTInsert your newly burnt INSERT disk on your computer, and tell your computer to boot from the CD-ROM (instructions for this, of course, vary, since this is a task to be done through the BIOS or the boot menu of your computer).Here's how your BIOS boot menu may look like. Place it in your wallet, or on your car's glove compartment - you'll end up needing it eventually. It fits on a business card-sized CD-R (normal CD-Rs are also okay). Automatic spell check in outlook for macYou'll see several lines, and each line will most probably begin with a /dev/hdXX or /dev/sdXX. View the contents of the /etc/fstab file: cat /etc/fstabShould show you the contents of that file. If you're not so lucky (or, perhaps, even luckier, and you have several disks) you'll have SATA or SCSI disks, one or more. Step three: fix your NTFS volumeIf you're like me, and you have an El Cheapo computer (which is, like, 99% of the world population) you'll have a single IDE disk. This is a bash shell.Do not be afraid. That's Linux.Here's how INSERT looks like when it's inspecting your computerAnd here's the INSERT prompt. You'll be able to back up your data onto other disks without touching anything from the source disks. Your computer should now boot normally Going beyondOf course, while using INSERT, there's a lot of things just waiting to be discovered. Let it check your disks.That's it. Don't forget to remove the CD-ROM as soon as the computer starts.Once Windows XP boots, you'll see it claiming that it needs to check the disks. Type sync then hit ENTER to ensure data to the disks is written, wait for two seconds, and then hit the reset button of your computer (or power it off and then back on). VoilĂ ! Your Windows XP system should be bootable again. ![]()
0 Comments
Leave a Reply. |
AuthorAngel ArchivesCategories |